Purlin Spacing For Metal Roofs

Once the purlin spacing is determined then the metal roofing panels are typically attached to every line of purlins.

Purlin spacing for metal roofs.

Spacing for purlins on a standard load most designs call for purlin placement at five foot intervals. An engineer will use a load chart in order to determine the spacing between metal purlins. Load tables specifying safe loads for different spans are available from metal deck manufacturers. A metal roof must also allow for some overlap on each side of the panels which will reduce the effective width of the panel.

The heavier the expected load is the shorter the distance between the purlins. However it is important to note that expected load is a crucial factor while determining this. However engineering determines the optimal spacing between the purlins. For heavier material such as gage steel the metal roof purlins spacing length could go up to 4 feet.

If the space between posts is greater than 8 feet then brace is needed to avoid buckling. Purlins are non pressure treated 1 x 4 x 12 lumber that is installed on to the roof in a specific layout pattern and screw pattern. Standard gage are generally used for roofing. Metal roof purlins are installed horizontally under metal roofs.

The spacing of purlins on roofs and girts on wall is usually 4 to 6 ft. They give added support to the roof and also provide a nailing surface for the end panels and drip edge. We do recommend it however. Purlins are 2 by 4 feet and are installed much like metal roofing.

Do all roofing projects require purlins. They are installed on top of the roof rafters with a felt underlayment or vapor barrier installed on top. By the standard the most used placement of purlin span for metal roof is five foot intervals. Screw line spacing for metal roofing over metal purlins.

For 2x6s purlins the posts are spaced in 6 feet distance. To determine how far apart to set rafters measure the width of the metal panel and then the width of the first hill and valley of the panel. The typical spacing standards for residential and commercial buildings are about 1 to 2 foot. Numbers 20 and 22 u s.

The purpose of the purlins is to provide a solid foundation for the metal roofing panels and trim to be screwed to.